A/C Heater Blower Motor W/Fan Cage For 2014-2016 Dodge Dart GT Front Replacing

Brand NEW Blower Motor For Car Features: NEW, not remanufacturedor rebuilt DIRECT REPLACEMENT Built to strict quality control standards HIGH QUALITY - Top quality materials which provide maximum strength and durability 1 YEAR WARRANTY-This item is backed by a 1 Year Warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge (excludes shipping charges) for the original purchaser 100% tested prior to leaving the factory What Are Signs Your Blower Motor Needs to Be Replaced? Poor or Airflow from Air Vents No Airflow At All From Vents Skyrocketing Energy Bills Strange Noises When You Turn on the Heat Overheating Blower / Weird Smells Fitting for the following years and models: 2014-2016 Dodge Dart Removing the Blower Motor Step 1 Disconnect the ground cable from the negative battery terminal. Loosen the retaining bolt using a wrench. Pull the clamp off the terminal Step 2 Locate the blower motor. On most vehicles, it will be located inside the engine bay along the firewall on the passenger side of the vehicle. On some vehicles, it may be located inside the passenger compartment, below the dash on the passenger side of the vehicle Step 3 Pull the wiring connector or connectors off the blower motor, using your hand. In most cases there will be one plastic connector. If there are more than one, use masking tape and a marker to label them for reassembly Step 4 Using a socket, unscrew the screws that secure the blower motor to the heater case or firewall Step 5 Pull the blower motor and fan blades from the vehicle as an assembly Step 6 Unscrew the nut that secures the fan blades to the motor, using a socket Step 7 Pull the fan blades away from the motor Installing the Blower Motor Drop the fan blades into position on the new motor Screw on the nut that secures the fan blades to the motor Slide the motor/fan blade assembly into position in the heater case or firewall Screw in the screws that secure the blower motor to the heater case or firewall Press the plastic wiring connector onto the back of the blower motor Reconnect the ground cable to the negative battery terminal. Slide the clamp over the terminal and tighten the retaining bolt with a wrench Test for proper operation NOTE: Please compare your parts against pictures to ensure this part fits your vehicle Please confirm your old part number matches up with one of the part numbers above Professional installation is highly recommended (No Instruction Included) For any needs please contact us