Brand NEW Blower Motor For Car
Features:
NEW, not remanufacturedor rebuilt
DIRECT REPLACEMENT
Built to strict quality control standards
HIGH QUALITY - Top quality materials which provide maximum strength and durability
1 YEAR WARRANTY-This item is backed by a 1 Year Warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge (excludes shipping charges) for the original purchaser
100% tested prior to leaving the factory
What Are Signs Your Blower Motor Needs to Be Replaced?
Poor or Airflow from Air Vents
No Airflow At All From Vents
Skyrocketing Energy Bills
Strange Noises When You Turn on the Heat
Overheating Blower / Weird Smells
Fitting for the following years and models:
2011-2016?Ford F-250 Super Duty2011-2016?Ford F-350 Super Duty2011-2016?Ford F-450 Super Duty2011-2016?Ford F-550 Super Duty2009-2013?Mazda 6
2011-2016?Ford F-350 Super Duty2011-2016?Ford F-450 Super Duty2011-2016?Ford F-550 Super Duty2009-2013?Mazda 6
2011-2016?Ford F-450 Super Duty2011-2016?Ford F-550 Super Duty2009-2013?Mazda 6
2011-2016?Ford F-550 Super Duty2009-2013?Mazda 6
2009-2013?Mazda 6
Removing the Blower Motor
Step 1
Disconnect the ground cable from the negative battery terminal. Loosen the retaining bolt using a wrench. Pull the clamp off the terminal
Step 2
Locate the blower motor. On most vehicles, it will be located inside the engine bay along the firewall on the passenger side of the vehicle. On some vehicles, it may be located inside the passenger compartment, below the dash on the passenger side of the vehicle
Step 3
Pull the wiring connector or connectors off the blower motor, using your hand. In most cases there will be one plastic connector. If there are more than one, use masking tape and a marker to label them for reassembly
Step 4
Using a socket, unscrew the screws that secure the blower motor to the heater case or firewall
Step 5
Pull the blower motor and fan blades from the vehicle as an assembly
Step 6
Unscrew the nut that secures the fan blades to the motor, using a socket
Step 7
Pull the fan blades away from the motor
Installing the Blower Motor
Drop the fan blades into position on the new motor
Screw on the nut that secures the fan blades to the motor
Slide the motor/fan blade assembly into position in the heater case or firewall
Screw in the screws that secure the blower motor to the heater case or firewall
Press the plastic wiring connector onto the back of the blower motor
Reconnect the ground cable to the negative battery terminal. Slide the clamp over the terminal and tighten the retaining bolt with a wrench
Test for proper operation
NOTE:
Please compare your parts against pictures to ensure this part fits your vehicle
Please confirm your old part number matches up with one of the part numbers above
Professional installation is highly recommended (No Instruction Included)
For any needs please contact us
